Bucket elevator: suitable for lifting from low to high, the supply material is fed into the hopper through the vibration table, and the machine automatically runs continuously to transport upwards. The conveying speed can be adjusted according to the conveying volume, and the lifting height can be selected as needed; The hopper is designed and manufactured by our company, and the PP non-toxic hopper makes this type of bucket elevator more widely used. All sizes are designed and manufactured according to actual needs. It is designed to be matched with vertical packaging machines and computer measuring machines, and is suitable for lifting and feeding products such as food, medicine, chemical industry products, screws, screw caps, etc. The automatic stop and start of the machine can be controlled by signal recognition of the packaging machine. Now lets talk about the installation of elevators:

1. Install the lower section first. The lower support surface of the bucket elevator should be ensured to be seated on the horizontal plane of the foundation, and the anchor bolts should be tightened after calibration. The allowable deviation of parallelism between the upper end face and the horizontal plane is 1/1000. Install the middle casing in sequence according to the markings, and allow the connection of the casing to be padded with waterproof canvas or asbestos tape to ensure sealing and adjustment. The lines of the lower and middle casings are required to be on the same vertical line, with a vertical deviation of no more than 1mm over a length of 1000mm and a cumulative height deviation of no more than 8mm. For dual channel casings, attention should also be paid to making the casings of the two channels level.

2. The main axis and the lower axis should be in the same vertical plane, and the centerlines of both axes should be parallel to the horizontal plane. The YY type drive devices low-speed shaft and main shaft should strive to be on the same axis, with a parallel offset of no more than 0.1mm and an axis angle of no more than

3. Before installing the upper section and drive device, carefully read the reducer manual. The reducer should be filled with sufficient industrial gear oil (see reducer manual for details). In order to prevent the hoist from shaking, there is a support device in the middle to prevent deviation. The distance between the support points should not exceed 8m, and the upper support points should be as close to the head as possible. Do not lift the support device to extend or retract in the vertical direction. The middle casing of the dual channel should be connected to the two channels with a connecting plate every 4 meters to enhance stability.

4. Install and run the later part. The chain of the chain bucket elevator should be selected so that the lengths of the two parallel chains are equal. After the running part is installed, the remaining stroke of the pulling device should be greater than half of the full stroke. When installing or adjusting the chain of the HL type dual channel elevator, the lifting steel groove on the middle casing can be used to lift and pull the chain wheel group. The method is to open the upper cover plate of the lower area and section, and hang a small lifting hoist on the steel groove to lift the chain wheel assembly.

5. The pulling device of the chain hoist adopts a heavy hammer tensioning method, and there should be enough heavy objects inside the heavy hammer box. Good adjustment of the hoist slide can reduce material return. Our factory has rubber plates on the hoist slide, and it is recommended to adjust the rubber plates at a distance of about 10mm from the outer edge of the hopper.

6. After the installation of the hoist is completed, check whether all fastening points are tightened. Add necessary lubricants to each lubrication system, rotate the transmission part by hand with ease and flexibility, and make the working chain rotate less than one revolution. After confirming that the installation is correct, the vehicle can be tested without load. First, run it for two or more instantaneous tests, then turn it on and run it for 2 hours without any problems. After that, a 16 hour load test should be carried out. At the beginning of the test drive, the material should be added to the required conveying capacity in three stages.